Drilling the body cavities
Had to get a Drill stand for drilling some portion off the cavities for neck, pickups and control cavity and battery compartment.
Doing this way will make the job off the router more easy since a large chunk off the wood was already taken out.
Doing this way will make the job off the router more easy since a large chunk off the wood was already taken out.
I used forstner bit 32 mm size for drilling. Since it has a center point witch is lower than the cutting section i will only drill shallow and will take rest with the router.
Drilling in the bridge humbucker is not accessible on the Drill stand base, i added some wood on top off the base so the body is resting again the main pipe where the drill is place, this allowed to drill in the bridge humbucker place.
1st Page - Previous Page - Next Page - Last Page
1st Page - Previous Page - Next Page - Last Page