PCB Holder - Vice for Welding
I built a holder for welding outside the cavity in the Bloody Mary build, based on this one Here.
At the time i did not finish it, so today i had a bit off time to complete it.
I removed all its parts except the T-Slot and sanded it and rounded the edges, then applied 1 coat off True-Oil.
At the time i did not finish it, so today i had a bit off time to complete it.
I removed all its parts except the T-Slot and sanded it and rounded the edges, then applied 1 coat off True-Oil.
One thing that i decided to add was sticky foam on the bottom board so it can be placed on top off any thing without scratching it.
Time to put all the pieces back on.
The PCB holder on top off my guitar stand, the sticky foam i got for protecting the necks, its just plumbing sticky foam, and i also used it in the Neck Support.