Amber - Page 9
Side Dots Install
Most off the work is basically all about the neck off the guitar, i currently have the work on the body almost finished. I have done a lot off the work on the neck on the last weeks, its was and still is very time consuming work.
Side dots are easily installed, i just did a rough estimate on the center spot off the fret area to drill and drilled it with 2 millimeter drill bit made the holes, its always easy to drill a guide hole with a smaller bit to avoid the drill slipping off the spot.
Drill the side dot.
Most off the work is basically all about the neck off the guitar, i currently have the work on the body almost finished. I have done a lot off the work on the neck on the last weeks, its was and still is very time consuming work.
Side dots are easily installed, i just did a rough estimate on the center spot off the fret area to drill and drilled it with 2 millimeter drill bit made the holes, its always easy to drill a guide hole with a smaller bit to avoid the drill slipping off the spot.
Drill the side dot.
Some super glue in the end off the dot and put in place. Gloves to not have fingers glued, and after this work i watched a video that super glue can be projected when is curing so its a god idea to use safety goggles so that it does not jump in to you’re eyes.
Cut it and sand slightly to level it.
From here is just repeat all over.
Side dots install complete, new work added to the list, when i applied the wudtone to the neck i was not planing on adding it the fretboard at that time since it there would be work done on the fretboard but i added it any way, so now it has to be redone.
1st Page - Previous Page - Next Page - Last Page
1st Page - Previous Page - Next Page - Last Page